Author Topic: over spray clean up  (Read 3978 times)

Offline t12345

  • Newbie
  • *
  • Posts: 1
over spray clean up
« on: December 01, 2015, 11:25:22 AM »
I had one of my guys over spray the exterior side of a factory pre finished stained fiberglass door while spraying the inside with latex through the door knob hole. Denatured worked a little, left in the grooves and grains still amd soap and water did touch it. Any suggestions that won't harm the factory finish?

Offline mymint87

  • PF God
  • *****
  • Posts: 623
Re: over spray clean up
« Reply #1 on: December 01, 2015, 04:23:10 PM »
welcome...i would use the gentlest means possible, soap and water and scrub with a soft brush, if any residue or paint remaining and its no too severe, think about matching the pigment in the grooves and getting paint to match and just use a rag to wipe it in the grooves covering up the overspray...good luck
I don't do this for a hobby and I'm damn sure I don't need the practice